1、开机System Controller Pre-Boot: 03 dev2.37 Flash Boot: NTDK34FA_r11 dev2.54 Reset Reason: 80, 6 - Reset due to CP and AP invoked reset SRAM: 128 kBytes DRAM: 32 MBytes, speed=60 ns Security ID: 20006127 type: NT_TCH System ID: N???6 Backup Flash: 1572 kBytes Program Store: 64 MBytes Flash Drive: 16 MBytes Dual ethernet expansion board #1 installed. IP DB MAC address 1: 00:90:CF:05:DA:A1 IP DB MAC address 2: 00:90:CF:05:DA:A2 Expansion board #2 not installed. Ethernet MAC address: 00:00:75:44:66:00 PCMCIA card installed in drive A. PCMCIA card not installed in drive B.
*** To invoke install setup program from PCMCIA enter CONTROL-I ***
2、按CONTROL-I
Executing power up self tests Power up self test passed CONTROL-I entered. Invoking install setup program from SW Delivery Card. DRAMOS load from SW Delivery Card successful.
*** OS RESTART ***
Communication Server 1000 Software Release : x210400t Created : Thursday September 16 08:23:35 EDT 2004 Loaded : 17/8/05 16:22:34
Copyright(C) 1972-2004 Nortel Networks. All Rights Reserved. VxWorks 5.2 Copyright(C) 1984-1997 Wind River Systems, Inc. All Rights Reserved. Use of the above software subject to terms of a license agreement. U.S. Government users subject to "Restricted Rights" under FAR & DFAR.
ssdrvAudit: Found erasable data track: 0-01 Loading AUXRES from disk.... Initialize Network Interface. Network Interface is up. Host : CSE30 IP Address : 20.10.10.10 Sub-netmask : 255.255.255.0
IPDB[1] FPGA Version is: 10 No FPGA upgrade required Unable to find startup script.
SOFTWARE INSTALLATION PROGRAM ************************************ Verify Security ID: 20006127 ************************************
|