新手请教，cisco2610路由器~...

我单位新购进一台cisco2610，想做为adsl宽带共享使用，应如何设置，最好能从头给我教一下，具体怎么做，谢谢各位。

wanghu0168 · 发表于 2004-2-17 10:58:00

我连怎么进入路由器配置都不知道，哪位先告诉一下，让我进去摸索一下先也好，很着急，非常感谢~

joyman · 发表于 2004-2-17 12:01:00

设一个出的INT口，一个入的IP段就来了

wanghu0168 · 发表于 2004-2-17 12:53:00

谢谢，能说具体一点吗？我用超级终端建了一个连接，可以和路由器通话了，怎么开始设置呢？找到的资料说开机按住cttl+c后，就可以开始自动提示设置了，我的不提示，怎么办？请指点~

liqiang0901 · 发表于 2004-2-17 13:11:00

2600接adsl有两种方式，一.WIC-ADSL 卡接线路 vpdn enable no vpdn logging ! vpdn-group pppoe request-dialin protocol pppoe ! inter f0/0 ip add 192.168.0.1 255.255.255.0 ip nat inside ip tcp adjust-mss 1450 ! inter ATM0 no ip address no atm ilmi-keepalive bundle-enable dsl operating-mode auto hold-queue 224 in interface ATM0.1 POINT-TO-POINT pvc 8/35 此处的pvc值8/35要根据具体情况而定，咨询电信 pppoe-client dial-pool-number 1 ! inter dialer1 ip address negotiated ip nat outside encap ppp dialer pool 1 ppp authen pap callin ppp pap sent xxxx pass xxxx 用户名密码 ! ip nat inside source list 1 interface dialer1 overload ip calssess ip route 0.0.0.0 0.0.0.0 dialer1 no ip http server ! access-list 1 permit 192.168.0.0 0.0.0.255 二.或者利用另外一个以太网口接到 ADSL MODEM再接线路 hostname xxxx ip name-server x.x.x.x dns的地址 vpdn enable vpdn-group pppoe request-dialin protocol pppoe inter f 0/0 ip add 192.168.0.1 255.255.255.0 ip nat inside inter f 0/1 no ip address pppoe enable pppoe-client dial-pool-number 1 inter dialer 1 mut 1492 ip address negotiated ip nat outside encap ppp no ip mroute-cache dialer pool 1 dialer-group 1 no cdp enable ppp authen pap callin ppp pap sent xxx pass xxx 用户名密码 ip nat inside source list 1 inter dialer 1 overload ip classless ip route 0.0.0.0 0.0.0.0 dialer1 permanent no ip http server ip pim bidir-enable access-list 1 permit any dialer-list 1 protocol ip permit